The 225 Bar DIN - Yoke fill adaptor enables 225 Bar DIN cylinders to be filled using yoke fill control valves. This adaptor is designed to be used for filling purposes only. The unit is of heavy duty construction with high quality chrome finish and manufactured from high strength brass.
Airdive will only supply adaptor systems for like filling pressures. Serious safety hazards exist when lower pressure fittings are adapted to fill higher pressure rated cylinders.
Also note that while DIN 300 regulator first stages might screw into both 225 DIN and 300 DIN cylinders, this is not the case with DIN 225 and DIN 300 filling spigots. They are purpose designed for different filling pressures.
If DIN 300 spigots are screwed into DIN 225 cylinder valve outlets then disengagement of the filling fitting from the cylinder could occur under pressure causing an obvious safety hazard to the fill operator. Always inspect thread engagement, rated fill pressure of cylinder and rated valve working pressure before filling DIN cylinders. Don't take risks with high pressure gases.
201530 INTERNATIONAL YOKE ADAPTOR
The Airdive yoke - 225 Bar DIN adaptor comprises the Airdive heavy duty yoke fitting and a 225 Bar DIN female adaptor. This adaptor allows the filling of standard k valve yoke cylinder valves from a 225 Bar DIN filling control valve. This adaptor can remain fitted to the DIN filling valve and removed when required to fill 225 Bar DIN cylinders.
Airdive follows the recommendations of the Australian Standards and suggests use of this product for cylinder filling purposes only.
225 BAR DIN MALE TO YOKE BLOCK ADAPTOR